Description
To protect the product from damage, we can vulcanize a soft rubber layer onto the rods. This rubber has a hardness of 30-35° shore. Because the rod is vulcanized over the total length, including the flattenings, this offers optimal protection. With these rods, the centre belt is attached with OGP. Because each rod must be vulcanized in a mold not every width is available.
Outer belt
DN-type belt with vulcanized Ø10 mm rods riveted onto it
Center belt with OGP32 hole pattern
Center belt with Ø10 mm rods riveted with OGP32 hole pattern
Sieve belt with flights
W10 rods and RM50 flights
Rod-to-rod measurement (Stokmaat)
G10 profile
O10 profile
C10 profile
W10 profile
To determine the correct width of the rivet bar, it is essential to have the accurate rod-to-rod measurement. This is the distance between the two outside rivet holes, C.T.C. When ordering loose rivet rods it is important that you mention the stokmaat as well as the distance between the holes in one end. Without further notice, we assume this distance to be 20mm in 50mm wide traction belts and 32mm in 60 or 75mm wide traction belts.